Best Overall
SunnyPoint Freestanding Holder with Storage
- Height: 23.6 in
- Weight: 3 lb
- Footprint: 7.7 x 7.1 in
- Spare Roll Storage: 3 rolls
Pros
- Four rolls in a 7.7-inch footprint
- Three-pound steel base that does not wobble
- Pre-installed screws make assembly a two-minute job
- Takes mega rolls in dispenser and reserve
Cons
- Tiny inset screws are easy to lose
Four rolls in a footprint of about 7.7 by 7.1 inches: one in use and three spares standing in a column behind it, on a stand 23.6 inches tall and 3 pounds heavy. It is the balance we keep coming back to, small enough for the gap beside a toilet with no wall to drill and substantial enough that it does not wander when you pull. When someone wants a freestanding holder and has no unusual requirement, this is the one we name.
Setup is two sections and the screws that come pre-installed in them, tightened down in a couple of minutes. We pay attention to that joint, because it is where a lot of stands cheap out — a friction fit that lets the top lift off the moment you carry the whole thing out to mop behind the toilet. These screws clamp the sections together instead.
The rolls are the other half of the story. Mega rolls fit the dispenser arm and the reserve column, which is the first thing we check on any of these, because a holder that only takes standard rolls is a holder you fight every week. Loading is a lift-and-drop: no spring dowel to wrestle, nothing to unscrew when a roll runs out.
What we flag is small. The two inset screws are genuinely tiny, and losing one mid-assembly is a real risk if you are working over a tile floor, so keep them in the tray until they are threaded. Snug them and forget them. Otherwise this stand asks nothing of you — no drilling, no wall, no trip to the cupboard halfway through a roll.